Carbide Advanz™ MC5 MC5 (Five Multiple Chips) Features • Exclusive Starrett tooth geometry • Carbide tipped • Ground tooth produces 5 chips • Utilizes a multiple chip grind with a high/low tooth sequence • Positive rake angle • Sub micron carbide (HV1600) Benefits • Higher productivity through reduced cutting time • Precision cuts - superb surface finish • Excellent "cost per cut" for production cutting • Starrett exclusive edge preparation - minimizes micro chipping • The chip load is spread out over more teeth to facilitate longer life Applications • Alloy tool steels • Aerospace alloys • Stainless steel • Nickel alloys • Automotive aluminum casting blocks • Cast iron Width x Thickness Pitch/Rake Material No. in mm 1-1/4 x .042 34 x 1.10 2-3/QC-P-T 92572 1-1/2 x .050 41 x 1.30 1.4-2/QC-P-T 92574 2-3/QC-P-T 92586 2 x .063 54 x 1.60 1.4-2/QC-P-T 92577 2-3/QC-P-T 92580 3-1/8 x .063 80 x 1.60 1.4-2/QC-P-T 92585 P - Positive rake | QC - Quintuple chip | T - Trapezoid set Furnished in welded bands. Special products on request. Now Available with NewAMPTechnology! The new AMP technology available on Starrett band saw blades increases cutting efficiency and blade life. A custom back edge enhancement on the blade generates a rocking motion while cutting which results in an increase in tooth penetration without added feed pressure. This cutting motion also serves to minimize surface contact area, increasing the blade life on hard to cut alloys. AMP AMP A v ailable with Technology 29 starrett.com C arbide NEW!